All terms
Glossary
More weight and balance terms
Shorter definitions of the other terms an airline's weight and balance data uses, each with the AHM 565 datasheets and the x565 elements that hold it.
Written by Jón Rúnar Baldvinsson · Reviewed by Kristján Óttar Rögnvaldsson · Updated
Certified weights: MTOW, MLW, MZFW and MRW
The maximum weights the manufacturer certifies for a type, often in several weight variants. Maximum ramp weight (MRW, also maximum taxi weight) is the most the aircraft may weigh moving on the ground, taxi fuel included; maximum take-off weight (MTOW) applies at the start of the take-off run; maximum landing weight (MLW) at landing; and maximum zero fuel weight (MZFW) to the aircraft without usable fuel. An airline may set lower operational maximums.
Example Air's A220-300 uses Airbus's published figures: 71,200 kg ramp, 70,900 kg take-off, 61,000 kg landing and 58,000 kg zero fuel.
In AHM 565:F1F2In x565:MaximumWeightsTableMinimumWeightsTable
Curtailment
Narrowing the manufacturer's center of gravity envelope into an operational one, to allow for what a load sheet cannot know: passengers not sitting where it assumed, crew and trolleys moving in flight, flaps and gear moving, and the fuel's density and burn.
In AHM 565:C6In x565:CurtailmentTable
Seat row trim
One of three ways a load sheet accounts for where passengers sit. Seat row trim counts passengers by the row they sit in and applies each row's balance arm; cabin area trim counts them by cabin section, and class trim by class. Seat row trim is the most exact, and needs the seat allocation.
Ideal trim line
The center of gravity, weight by weight, that an airline aims to load to inside its limits, usually toward the aft limit, where the aircraft needs less trim and burns less fuel.
In AHM 565:C7In x565:IdealTrimLineTable
Tipping and lateral imbalance limits
Limits for the aircraft on the ground. A tipping limit is the aftmost center of gravity before the aircraft would sit back on its tail, which matters while it is loaded and unloaded; a lateral imbalance limit caps how much more weight one side may carry than the other.
In AHM 565:C7In x565:TippingLimitTableLateralImbalanceLimitTable
Decks, holds, compartments and positions
AHM 565 describes where load can go as a hierarchy. A deck holds holds, a hold holds compartments, and a compartment holds positions: bays for bulk load, or positions for unit load devices. Each states its balance arm, its extent and its maximum weight, and the passenger cabin's sections and seat rows sit on a deck in the same way.
In AHM 565:D1D2D3D5D8In x565:DeckHoldHoldCompartmentULD_LoadPositionCabinSectionSeatRow
Weight and balance, mass and balance
The same discipline in two vocabularies. EASA and ICAO say mass: dry operating mass, traffic load, take-off mass. The FAA and the manufacturers say weight: dry operating or basic operating weight, payload, take-off weight. The definitions differ at the edges; the FAA's payload, for example, does not include the ballast that EASA's traffic load does.
Tekna is independent of IATA. AHM 565 and x565 are IATA's.
Book a demo
Safety-critical data deserves a proper system of record
A 30-minute call on Google Meet: 15 minutes to show you the platform, 15 for your questions.